| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
5.
Note wire locations on terminals of starter.
6.
Using 11/16-inch wrench loosen nuts (1 and 2) and remove drain down tubing (3) (MK1 only).
7.
Remove two nuts (4), washers (5) and wires from terminals (6) using 8-mm box wrench.
8.
Remove two nuts (7), washers (8) and battery cables from terminals (9 and 10) using 1/2 inch box
wrench.
9.
Use socket with extension to remove three bob (11) and washers (12) securing starter (13 to flywheel
housing. Remove starter.
INSTALL:
1. Position end of starter (13) in opening of flywheel housing.
2.
Align starter mounting holes with holes in flywheel housing.
3.
Install three washers (12) and bolts (11) and tighten with socket and extension.
NOTE
Battery cables have a lettered plastic clip for identification.
Starter terminals are identified by letter stamped on starter at
terminal.
4.
Connect battery cable marked B or C to terminal (B+).
5.
Connect battery cable marked F and C or K to terminal (R-).
6.
Install two washers (8) and nuts (7) and tighten using 1/2 inch box wrench.
7.
Install two wires on solenoid terminals (6) in accordance with tagging.
8.
Install two washers (5) and nuts (4) and tighten using 8-mm box wrench.
9.
Reinstall drain down tubing (3) and tighten nuts (1 and 2) using 11/16 inch wrench (MK1 only).
10.
Replace buoyancy flotation material if removed (refer to paragraph 3-152).
11.
Connect batteries (refer to paragraph 3-89).
12.
Close hatches.
3-254
|
||
|
||
