| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
INSTALL:
1.
Connect turbocharger oil drain elbow (16) and locknut (24) on turbocharger (6). Tighten using 1-1/4-
inch crowfoot wrench.
2.
Connect turbocharger oil feed pipe (18) to turbocharger (6) and tighten fitting (23) using 5/8-inch
crowfoot wrench. Orient feed pipe in direction shown in figure.
3.
Fit gasket (22) and turbocharger (6) to exhaust manifold (21).
4.
Install four washers (20) and bolts (19) loosely. Do not tighten at this time.
5.
Connect air intake hose (8) to turbocharger (6). Do not tighten.
6.
Connect drain pipe (25) to turbocharger oil drain elbow (16). Do not tighten.
7.
Connect intercooler hose (10) to turbocharger (6). Do not tighten.
8.
Tighten bolts (19) using 9/16 inch wrench.
9.
Tighten hose clamp (7) using screwdriver.
10.
Tighten hose clamp (9) using screwdriver.
11.
Tighten hose clamp (15) using screwdriver.
12.
Connect fitting (17) on turbocharger oil feed pipe (18) to engine block.
13.
Tighten fitting (17) using 19 mm open end wrench.
14.
Install gasket (14), exhaust elbow (13), and four washers (12) and bolts (11) on turbocharger (6).
15.
Tighten bolts (11) using 1/2 inch socket.
16.
Reinstall heat shield (3) over turbocharger (6).
17.
Install four washers (5) and bolts (4) holding heat shield (3) to exhaust manifold (21).
18.
Tighten bolts (4) using 1/2 inch socket.
19.
Install three washers (2) and bolts (1) on heat shield (3).
20.
Tighten bolts (1) using 1/2 inch socket.
21.
Wipe spilled oil from engine parts.
22.
Close engine hatches.
3-259
|
||
|
||
