INSTALL - TM-5-1940-277-200484

Custom Search

REMOVE

TM-5-1940-277-20 Boat Bridge Erection Twin Jet Aluminum Hull MODEL USCSBMK1 (1940-01-105-5728) MODEL USCSBMK2 (1940-01-218-9165) Manual

BUOYANCY MATERIAL REMOVAL AND INSTALLATION INSTRUCTIONS

TM5-1940-277-20

TM 1940-20/2

Using old section of fendering (rubber rub rail) as guide, locate and drill 1/2 inch holes (6) in flat side of new section

of rub rail.

Locate and drill socket access holes (7) in curved side of fendering (rub rail) using hole cutter.

Discard old fendering (rub rail).

INSTALL:

Slide new section (8) of fendering (rub rail) into position on metal insert (9).

From inside of boat insert bolts (3) through gunwale (10), fendering (rubber rub rail) (5) and metal insert (4).

NOTE

Bolt heads must be flush with flange an gunwale so that bolt will not turn when metal in-

sert and fendering (rub rail) are installed and nut is attached.

Replace washers (2) and nuts (1) through fendering (rubber rub rail) and tighten using socket and extension.

3-320