| Tweet |
Custom Search
|
|
|
||
 TM 5-2010-205-14
NOTE
Normal operating temperature (coolant) is 160 to 185 F (71 to 85 C).
b. Warm-up. Run engine at part throttle and no load for approximately 5 minutes to allow the engine to warm up
before applying a load.
c. Inspection . While engine is running at operating temperature, perform all during (D) PMCS operations.
d.
Idling . When prolonged engine idling is necessary (no-load), maintain at least 800 rpm.
e.
Check the location of the propeller by observing the direction indicator.
f.
Advance throttle knob slowly until the tachometer reads desired speed, but not to exceed 2400 rpm.
g. Insure the propeller stem is at an angle that will allow the propeller to be fully water covered, but still permitting
draft in shallow water.
h.
Engage forward-reverse lever to desired direction and magnitude of propulsion.
i.
Use steering wheel to direct the vessel towards desired destination.
2-11.
STOPPING.
a. Normal Stopping . Remove load by positioning the forward reverse lever in its center or neutral position and
set throttle to 800 rpm. Allow engine to run at this speed for four or five minutes and then turn the key to stop position.
b. Emergency Stopping. Press down on emergency stop lever. c. Inspection. Perform all After (A) PMCS.
Check all lines for leaks. Clean as necessary.
c.
Inspection . Perform all After (A) PMCS. Check all lines for leaks. Clean as necessary.
2-14
|
||
|
||
