| Tweet |
Custom Search
|
|
|
||
 TM 5-2805-261-13
LOCATION/ITEM
ACTION
REMARKS
4-27. CARBURETOR MAINTENANCE -continued
3. Core plug (2), (3)
Place in casting opening
with convex side up.
4. Core plug
Use a hammer and a flat
Check for leakage after carburetor is installed. (See
end center punch to rap
into position.
LEAD SHOT
REPLACEMENT
1. Lead shot (4)
Check for leaks.
Usually a sharp rap with a flat end center punch and a
hammer will stop the leak.
2. Lead shot (4)
Pry out with sharp tool.
3. Lead shot (4)
Place new lead shot in hole
and rap into place with a
flat end center punch and
hammer.
NEEDLE VALVES
1. Inlet needle valve
Remove.
Figure 4-26. Inlet needle valve and seat
clip (5)
2. Inlet needle valve (6)
Remove.
Check for grooves, nicks or scratches. Replace if
necessary.
3. Inlet needle valve seat
Inspect with magnifying
Check for nicks, grooves or scratches. Turn out of
glass.
casing and replace if necessary.
4. Slow speed needle
Turn out of casing.
Inspect for nicks, grooves, scratches, and off-centered
valve (7)
condition. Replace if necessary.
4-43
|
||
|
||
