| Tweet |
Custom Search
|
|
|
||
 TM 5-2805-261-13
4-28. CARBURETOR REMOVAL/INSTALLATION
This task covers:
Removal/installation of carburetor
INITIAL SETUP :
Tools:
Equipment Condition:
Motor OFF
T6 325043
Materials/Parts:
Gasket - 325092
Personnel Required:
Approximate Time Required (minutes):
1 Mechanic
45
LOCATION/ITEM
ACTION
REMARKS
REMOVAL
1. Screw (1)
Back off until loose.
2. Choke arm (2)
Slide off shaft.
3. Tie down on inlet hose
Remove.
4. Inlet hose
Slide off carburetor inlet.
5. Nuts (3) and lock-
Remove.
Figure 4-28. Carburetor
washers (4)
6. Carburetor and
Remove.
Replace gasket. Inspect flanges for nicks and cuts.
gasket (5)
Finish with fine emery cloth (120 and then 180
grit) if necessary.
INSTALLATION
1. Carburetor and gasket (5)
Place in position.
2. Nuts (3) and lock-
Install.
washers (4)
3. Inlet hose
Install on carburetor inlet
and secure with tiedown.
4. Choke arm (2)
Slide onto shaft and secure
with capscrew (1).
5. Motor
Start.
See para 2-8.
6. Carburetor
Adjust.
See para 3-17.
Inspect carburetor for leaks.
4-45
|
||
|
||
