| Tweet |
Custom Search
|
|
|
|
||
|
||
 the gear housing. Then, remove clamps, board, and blocks.
NOTE
The ends of the retaining ring, when installed in the gear housing, must always be directly
above the oil drain hole in the gear housing.
(p) Install a retaining ring retaining spring pin (20) in each of the three holes in the forward face of the drive
plate. Then, tap the spring pins in the drive plate to within 1/16 inch of the outer surface of the retaining ring with a punch
and hammer.
(q) Lubricate the planetary gear thrust washer (7) with engine oil. Then, place the thrust washer over the
reverse gear drive shaft and against the oil transfer sleeve.
(r) Lubricate one of the reverse sun gear thrust washers (26) with engine oil. Then, place the thrust
washer over the planetary hub and against the inside face of the hub.
(s) Place the sun gear over the planetary hub and through the planetary gears (large inside diameter of
sun gear facing up), and against the thrust washer, (fig. 3-89).
(t) Place the planetary gear assembly with sun gear over the end of the drive shaft (oil collector ring side
facing the ring gear) as shown in figure 3-94. Aline the splines in the sun gear with the splines on the drive shaft. Slide the
assembly straight back on the drive shaft and through the ring gear until it contacts the planetary gear thrust washer.
3-133
|
||
|
||
