| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-217-34
Figure 3-93. Installing reverse clutch plate and drive plate assembly into reverse rear housing.
NOTE
Immerse the reverse clutch plate in a light grade of engine oil for approximately one-half
.
hour before assembling in the gear housing
5. Raise the reverse clutch drive plate, clutch plate and release springs up to a near
vertical position. Then, lift the drive plate assembly and pilot it over the drive shaft, as shown in
tipping forward or the release springs from dropping out of the drive plate.
6. Push the drive plate assembly straight into the gear housing until the release
springs contact the reverse clutch piston.
7. Rotate the reverse clutch drive plate and align the dowel pin slots in the periphery of
the drive plate with the slots in the gear housing. Install the three dowel pins (2, fig. 3-89) and
push the pins in flush with the forward face of the plate.
(o) Install the reverse clutch drive plate retaining ring (21, fig. 3-88) in the gear housing as
follows:
1. Place the retaining ring in the reverse gear housing and against the drive plate, with
the open ends of the retaining ring at the bottom of the gear housing (fig. 3-90).
2. Clamp a board across the face of the gear housing with a 1 inch wood block at each
end between the board and the drive plate.
3. Tighten the clamps and draw the drive plate straight into the gear housing until the
retaining ring groove in the housing is exposed.
4. If the three dowel pins (2, fig. 3-89) extend above the face of the drive plate, push or
tap the pins down flush with the face of the drive plate.
5. Starting at the lower edge of the gear housing, feed the retaining ring in the groove
in
3-132
|
||
|
||
