Tweet |
Custom Search
|
|
|
||
TM 55-1905-217-34
(b) Measure clearance (Y, fig. 4-46) with feeler gages at points "V" and "W" as indicated. Also measure
clearance "Z" at points "V" and "W". For good alinement, clearance "Y" should be equal when measured at
points "V" and "W" within .005 inch. Clearance "Z" should also be equal when measured at "V" and "W" within
.005 inch. Clearance "Y" does not require to be equal to clearance "Z". If the clearances measured at "V" and
"W" are not within .005 inch, install shims under corner of the winch base until clearances "V" and "W" are
within .005 inch when the winch is bolted solidly to its mounting.
Figure 4-46. Winch alinement.
4-72
|
||