| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-7. VARIABLE SPEED MECHANICAL GOVERNOR-MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL-INSPECTION (Cont)
d. Governor
Insert the end of the assembly through
operating
the upper bearing bore in the housing
shaft (81),
with the lever positioned as shown.
bearing
(84), spacer
(85), and
lever (83)
assembly
e. Operating
Lubricate the inside diameter of the
shaft fork
governor operating shaft fork with
(82)
engine oil, then place the operating
fork over the lower end of the shaft
with the finish cam surfaces on the fork
fingers facing the rear of the governor
housing and the flat on the shaft regis-
tering with the flat surface in the fork.
f.
Governor
1. Support the governor housing and
housing
operating shaft assembly on the bed of
(18) and
an arbor press with the upper end of
operating
the operating shaft resting on a steel
shaft
support as shown.
assembly
2. Place a 7/16" inside diameter sleeve
over the end of the shaft and against
the fork; then, press the fork tight
against the shaft spacer on the shaft.
5-197
|
||
|
||
