| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-35. BLOWER - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL - ASSEMBLY (Cont)
f.
Blower
1. Reverse the blower
housing
housing on the
(50), and
bench (rear end of
rotors
housing facing the
(48 and
outside of the
49)
bench).
2. Place the rotors in
mesh with the
omitted serrations
in the rotor shafts
in a horizontal
position and facing
to the left as viewed
from the gear end.
NOTE
The right-hand helix rotor is marked "GEAR END" on one end.
The gear end of the left-hand rotor is that end which has the
serrated shaft.
3. Install an oil seal
pilot J6270-5 over
the opposite end
of each rotor shaft.
4. Insert the rotors
straight into the
housing and through
the front blower end
plate.
5. Remove the oil seal
pilots from the rotor
shafts.
5-568
|
||
|
||
