| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-35. BLOWER - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL - ASSEMBLY (Cont)
2. Position the end plate
(47) in front of the
blower housing with the
top side of the end
plate facing up. Then,
start the dowel pins
(55) straight into the
dowel pin holes in the
housing. Push or tap
the end plate against
the housing.
NOTE
Gaskets are not used between the end plates and the housing;
therefore, the mating surfaces must be perfectly flat and
smooth.
3. Insert the two screws
(44) through the end
plate and thread them
into the housing.
Tighten the screws
securely. Do not use
lockwashers on these
screws.
5-567
|
||
|
||
