| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-65.2 DISCONNECT CLUTCH-ANCHOR WINCH-MAINTENANCE INSTRUCTIONS
(Continued).
LOCATION
ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
e. ALTERNATE METHOD.
An arbor or drill press may be used to compress the springs if preferred. Place
block across the top of the spring retainer for this operation. Install two 3/8 inch x
16 x 3 inches hold-down screws opposite one another through the holes in the
spring retainer and thread into aligning tapped holes in the pressure plate provid d
e
for this purpose to hold the springs fully compressed.
NOTE
Screws 3/8 inch by 16 x 5 inches long may be left in place
until after the clutch in installed in the engine flywheel, or two
standard 3/8 inch by 16 x 3 inch bolts installed at right angles to
5 inch screws to hold the springs compressed,and remove
long screws. IMPORTANT: The 5 inch screws or hold-down
screws must remain in place until the clutch has been bolted into
the engine flywheel.
5-840
|
||
|
||
