| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-6
3-167.2. FLYWHEEL HOUSING - MAINTENANCE INSTRUCTIONS.
a. The flywheel housing is a one-piece casting, mounted against the rear cylinder block end plate, which
provides a cover for the gear train and the flywheel. It also serves as a support for the starting motor and the
torque converter.
b. The crankshaft rear oil seal, which is pressed into the housing may be removed or installed without
removing the housing (see paragraph 166).
This task covers:
a. Removal
b. Inspection
c. Installation
INITIAL SETUP
Test Equipment
References
Paragraph
Concentricity test
Gauges
Overspeed Governor
Tachometer Drive
Oil Pan
3-174
Instrument Panel
3-176
Starter Motor
Equipment
Special Tools
Condition
Condition Description
Paragraph
Studs (four)
1/2-13 x 3 1/4 lg.
Torque Converter Removal
Chain hoist
Overspeed Governor Removal
Hammer (soft)
Tachometer Drive Removal
Oil Pan Removal
Flywheel Removal
3-174
Instrument Panel Removal
3-176
Starter Motor Removal
Material/Parts
Special Environmental Conditions
Gasket kit P/N 5193114
None
Personnel Required
General Safety Instructions
2
None
3-2873
|
||
|
||
