| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-7
3-171.4. Cylinder liner - maintenance instructions (Continued).
LOCATION
ITEM
ACTION
REMARKS
INSPECTION (Cont)
8.
Cylinder
liner,
piston and
connecting
rod assembly
NOTES
1. If any of the pistons and liners are already in the engine, use hold-down
clamps to retain the liners in place when the crankshaft is rotated.
2. Rotate the crankshaft until the connecting rod journal of the particular cy-
linder being worked on is at the bottom of its travel. Wipe journal clean and lubr-
cate it with clean engine oil.
a. Upper
Install in connecting
The upper bear-
bearing
rod (2). Lubricate.
ing shell does
shell
not have a con-
(1)
tinuous oil
groove. Lubri-
cate the bear-
ing shell with
clean engine
oil.
NOTE
Each connecting rod and its cap is numbered on one side - 1L, 1R, 2L, 2R, etc.
These numbers and letters identify the caps with the rods and indicate
the particular cylinder in which they are used. Maintain these positions when
assembling the engine.
b. Piston,
1. Position the piston,
rod and
rod and liner assem-
liner
bly in front of the
assembly
cylinder block bore
(3)
so the identification
number and letter on
the rod face the outer
edge of the cylinder
block, and the match-
marks on the liner and
block are in alignment.
3-2978
|
||
|
||
