| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-1
Table 2-1. PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) - continued
Location
Item
Item To Check/
Not Fully Mission
No
Interval
Service
Procedure
Capable If :
181
ANNUAL
Anchor Winch
HYDROSTARTER. Remove the
Compartment
hydrostarter from the engine for
lubrication. Before removing the
hydrostarter, release the pressure in
the system by means of the relief
valve (40) on the hand pump (41).
Then remove three bolts (42) and
washers (43) that attach starting
motor (44) to the flywheel housing.
Remove the starting motor without
disconnecting the hydraulic hoses.
Apply a grease (MIL-L-24139A (SH))
on drive clutch pinion (45) so that it
will slice freely while compressing
spring. Also apply grease to the
fingers of clutch fork (46) and spool
of clutch yoke (47).
Remove pipe plug (48) from starting
motor drive housing (44) and
saturate shaft oil wick (49) with
engine oil. Re-install the plug (48).
After lubricating, install starting motor
on the flywheel housing and
recharge the accumulator with the
hand pump.
Change 5 2-235
|
||
|
||
