Custom Search
 
  
 
TM 55-1905-220-14-5
3-15. FLYWHEEL HOUSING-MAINTENANCE INSTRUCTIONS (Cont).
a. The flywheel housing is a one-piece casting, mounted against the rear cylinder block end plate, which
provides a cover for the gear train and the flywheel. It also serves as a support for the starting motor and the
generator.
b. The crankshaft rear oil seal, which is pressed into the housing, may be removed or installed without
removing the housing (paragraph 3-91).
This task covers:
a. Removal
b.
Inspection
c.
Installation
INITIAL SETUP:
Test Equipment
References
Concentricity Test
Para 3-79
Overspeed Governor-Removed
Gauges
Para 3-80
Tachometer Drive Removed
Para 3-88
Oil Pan Removed
Para 3-99
Instrument Panel-Removed
Para 3-101
Starter Motor-Removed
Equipment
Special Tools
Condition
Condition Description
Para
Chain hoist
Hammer (soft)
3-63
Generator-Removed
Studs (four)
3-79
Overspeed Governor-Removed
1/2-13 x 3 1/4 lg.
3-80
Tachometer Drive Removed
3-88
Oil Pan Removed
3-92.1
Flywheel Removed
3-99
Instrument Panel-Removed
3-101
Starter Motor-Removed
Material/Parts
Special Environmental Conditions
Gasket kit P/N 5193113
NONE
Personnel Required
General Safety Instructions
2
NONE
3-1591

 


Privacy Statement - Copyright Information. - Contact Us

 Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business