| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-2
5-13.2.
HYDRAULIC STARTING MOTOR (Continued).
LOCATION/ITEM
ACTION
REMARKS
DISASSEMBLY (Cont)
NOTE
There is a slight spring load on the port plate.
Upon loosening the
screw, any oil left in the housing will drain out.
f.
Remove port plate screws (8),
and lockwashers (9) from the
port plate, and remove port
plate (7).
g.
Invert housing (4) allowing
barrel (10) and pistons (11)
to slide off drive shaft (6).
h.
Remove pistons (11) from
barrel (10).
i.
Remove retaining ring (12)
from drive shaft.
j.
Press drive shaft (6) out of
Seals (13, 14 and
housing (4) from port plate
15), seal holder
end.
(16), retaining
ring (17), and
shaft bearing
(18) will come
out with shaft.
k.
Remove inner seal (13),
Remove only if
slipper seal (14), outer
defective.
seal (15), seal holder (16)
from drive shaft.
l.
Remove retaining ring (17),
and shaft ball bearing (18)
from drive shaft.
m.
Press against thrust bearing
housing (19) with a little
pressure and remove thrust
bearing assembly.
5-214
|
||
|
||
