| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-2
5-13.2.
HYDRAULIC STARTING MOTOR (Continued).
LOCATION/ITEM
ACTION
REMARKS
ASSEMBLY (Cont)
b.
Install nameplate (32)
If removed.
using two screws (31).
c.
Press needle bearing (30)
If removed.
into pinion gear housing (3).
d.
Install roller bearing (29)
If removed.
in port plate (7), securing
with retaining ring (28).
e.
Install adapter fitting
If removed.
gaskets (27), and adapter
fittings (26).
f.
Install washer (25), spring
(24), and washer (23) onto
motor barrel (10).
g.
Install dowel pin (22).
If removed.
h.
Press thrust bearing (21)
Press in housing
into housing (19), and
until it bottoms
install housing (19), and
against housing
thrust bearing plate (20).
(4). Be sure
dowel pin (22)
is in place.
i.
Install drive shaft ball
bearing (18) on drive shaft,
and secure with retaining ring
j.
Install with seal holder (16).
k.
Install outer seal (15),
slipper seal (14), and inner
seal (13) onto drive shaft.
l.
Press assembled drive shaft (6)
into housing (4) from port
plate end (7).
m.
Secure with retaining ring (12).
n.
Install pistons (11) onto barrel
(10), and install barrel (10).
5-220
|
||
|
||
