| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-2
5-14. ROCKER ARMS, CAM FOLLOWERS AND PUSHRODS (Continued).
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION (Cont)
18. Governor
a. Position a new gasket (25)
in place on governor weight
housing (23).
b.
Start splined end (26) of
weight shaft in the upper
blower rotor.
c.
Position housing (23) against
blower end plate.
d.
Install new copper gasket
(27) onto each housing-to-
blower bolt.
e.
Install housing-to-blower
Finger-tight
bolts (24) into blower end
only.
plate.
f.
Place new gasket over dowels
and against the side of the
weight housing facing engine.
g.
Move thrust bearing assembly
(28) and riser (29) toward
weight end of shaft (23).
NOTE
The finished surface of the operating fork must be
placed against outer side of thrust bearing.
h.
Position lower end of control
housing (22) over dowel pins
in weight housing (23).
i.
Install new gasket (21) to
governor control housing (22).
j.
Secure housing (22) to cylin-
der head with spacer (20),
two lockwashers (19), and
bolts (18).
5 -300
|
||
|
||
