| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-2
5-14. ROCKER ARMS, CAM FOLLOWERS AND PUSHRODS (Continued).
LOCATION/ITEM
ACTION
REMARKS
ADJUSTMENTS (Cont)
b.
Positioning The Injector
Rack Control Levers: The
position of the injector
racks must be correctly set
in relation to the governor.
Their position determines the
amount of fuel injected into
each cylinder and ensures
equal distribution of the
load. Adjust the No. 1
injector rack control lever
first to establish a guide
for adjusting the remaining
injector rack control levers.
1.
Disconnect any linkage
attached to the governor
speed control lever.
2.
Loosen the idle speed
adjusting screw locknut
and back out the idle
speed adjusting screw
until 1/2 inch (1.27 cm)
of the threads project
from the locknut when the
nut is against the high
speed plunger.
3.
Loosen all the inner (1)
and outer (2) injector
rack control lever
adjusting screws. Be sure
all the control levers are
free on the injector
control tube.
4.
Move the governor speed
control lever (3) to the
maximum speed position as
shown in figure below.
Hold lever in that position
with light finger pressure.
Turn the inner adjusting
5-314
|
||
|
||
