| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-2
5-14. ROCKER ARMS, CAM FOLLOWERS AND PUSHRODS (Continued).
LOCATION/ITEM
ACTION
REMARKS
ADJUSTMENTS (Cont)
7.
The setting is too tight
if, when moving the speed
control lever from the
idle to the maximum speed
position, the injector
rack becomes tight before
the speed control lever
reaches the end of its
travel as determined by
the stop under the governor
cover). This will result
in a step-up in effort
required to move the speed
control lever to the end
of its travel. To correct
this condition, back off
the inner adjusting screw
slightly and tighten the
outer adjusting screw
slightly.
8.
Disconnect the fuel rod
from the injector control
tube and manually hold
the No. 1 injector in the
full-fuel position and
turn down the inner
adjusting screw of the
No. 2 injector until the
injector rack has moved
into the full-fuel posi-
tion, and the inner
adjusting screw is
bottomed on the injector
control tube. Turn the
outer adjusting screw
down until it bottoms
lightly on the injector
control tube. Then,
alternately tighten both
the inner and outer
adjusting screws.
5-318
|
||
|
||
