| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-2
5-14. ROCKER ARMS, CAM FOLLOWERS AND PUSHRODS (Continued).
LOCATION/ITEM
ACTION
REMARKS
ADJUSTMENTS (Cont)
26. Throttle
The throttle linkage may be
Controls
adjusted after setting the
Adjustment
valves, timing the injectors ,
adjusting the governor and the
injector operating linkage as
follows:
a.
With engines stopped, set
the throttle control cross
shaft so that the throttle
control levers (1) are in a
vertical position as shown at
"A -A A".
b.
With engines stopped, adjust
turnbuckles on the two
throttle control rods so
that pins in the throttle
control levers at governor
cover rest against the
shoulders of the control
cams (2) in the "IDLE"
position at the two
governors.
c.
Now move the master throttle
(3) to "FULL" open position,
at which setting the pin
in throttle lever (4) at
both governors should just
strike the extreme end of the
slot in the cam (2) at the
"RUN" position. If either or
both pins do not reach end of
slot in cams, adjust turn-
buckles (5) to bring about
this condition.
5-324
|
||
|
||
