| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-2
5-15.
CYLINDER HEAD (Continued).
LOCATION/ITEM
ACTION
REMARKS
REPAIR/REPLACEMENT (Cont)
3.
Install the nozzles flush to
1/32 inch below (recessed)
the bottom surface of the
cylinder head; otherwise,
interference with proper
seating of the head on the
cylinder block may be
encountered.
4.
Check to make sure the
nozzles fit tight in the
cylinder head. If the water
holes have been enlarged by
corrosion, expand the
nozzles by means of a wood
plug or other suitable tool,
or tin the outside diameter
with solder to provide a
tight fit. If solder is
used, exercise care so that
the orifices in the nozzles
are not closed with solder.
d.
Install valve guides (7) as
follows:
1.
Turn the cylinder head (29)
right side up on the work
bench.
2.
Insert the internally
Use tool J9530.
threaded end of the valve
guide (7) in the valve guide
Installing tool.
Be sure to use the correct tool (J9530) to avoid damage to the valve
guide, and to locate the valve guide to the proper dimension above top
of head.
5-364
|
||
|
||
