| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-2
5-17. FUEL PUMP (Continued).
LOCATION/ITEM
ACTION
REMARKS
ASSEMBLY (Cont)
i.
Apply a thin coating of seal-
ant on the face of the pump
cover (6) outside the gear
pocket area. Then, place the
cover against the pump body
with two dowel pins (20) in
the cover entering holes in
the pump body.' The cover can
be installed in only one
position over the two shafts.
CAUTION .
The coating of sealant must be extremely thin since the pump clearances have
been set up on the basis of metal-to-metal contact. Too much sealant could
increase the clearances and affect the efficiency of the pump. Use care that
sealant is not squeezed into the gear compartment; otherwise damage to the
gears and shafts may result.
j.
Secure the cover in place
with eight bolts (4), and
lockwashers (5), tightening
the bolts alternately and
evenly.
k. After assembly, rotate the
pump shaft by hand to make
certain that the parts rotate
freely. When the shaft does
not rotate freely, attempt to
free it by tapping a corner
of the pump.
l. Install drain plug (3).
If removed.
m. Install drain adapter (2).
If removed.
n. Install fuel line connector
If removed.
adapters (1).
5-396
|
||
|
||
