| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-3
6-23.3.
CAMSHAFT AND BALANCE SHAFT - MAINTENANCE INSTRUCTIONS.
(Continued).
LOCATION/ITEM
ACTION
REMARKS
REMOVAL - FLYWHEEL HOUSING AND MARINE GEAR REMOVED (Cont)
c.
The three screws (22), and
lockwashers (23) that secure
the balance shaft bearing to
the rear end plate of the
engine may be removed by
inserting a socket wrench
through the hole in the webs
of the balance shaft drive
gear (24).
d. Remove balance shaft and gear
assembly from cylinder block.
NOTE
If the thrust washers (25) located between the bearing
and thrust shoulders at the front end of the shaft on
the "B" engines are not removed with the shafts, they
should be pulled out when removing the be rings,
a
proceed to step e.
6-339
|
||
|
||
