| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-35. BLOWER ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
39. Rear End
Attach the blower rear end plate (88)
Plate
to the blower housing (92) as follows:
and Pins
(1)
Reverse the blower housing
(92) on the bench (rear end of
housing facing the outside of
the bench).
(2)
Place an oil seal pilot
J6270-5 on the serrated end
of each rotor shaft (100).
NOTE
When oversize oil seals are used in the blower end plate, use oil seal spacer installer J1682-13 for
the oil seal pilots in place of J6270-5.
(3)
Check the dowel pins (94).
The dowel pins must project
.380" from the flat inner
face, and .270" from the outer
face of the rear end plate to
assure proper alignment of the
end plate to the housing and
cover to the end plate.
6-674
|
||
|
||
