| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-35. BLOWER ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
(4)
Place the rear end plate (88)
in position in front of the
oil seal pilots with the flat
finished face of the end
plate facing the blower
housing and the mark TOP on
the end plate at the top
flange side of the housing.
(5)
Place the rear end plate (88)
over the oil seal pilots and
start the dowel pins (94)
straight into the dowel pin
holes in the housing. Push
or tap the end plate against
the housing.
(6)
Insert the two fillister head
screws (87) through the end
plate (88) and thread them
into the housing (92).
Tighten the screws securely.
Do not use lockwashers on
these screws.
(7)
Remove the oil seal pilots
from the rotor shafts.
6-675
|
||
|
||
