| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-36. TRANSMISSION OIL PUMP (Continued).
LOCATION/ITEM
ACTION
REMARKS
ASSEMBLY (Cont)
NOTE
The step under the shoulder of the installer properly locates the bushing in the oil
pump body and cover.
(6) With the bushing installed
in the oil pump cover,
open the oil bleed hole in
the cover with a 1/8" drill,
entering from the rotor
side of the cover.
c. Blow the drill chips out of
the oil pump cover (19). Then,
attach the oil pump cover to
the pump body with two screws
placed diametrically opposite
each other.
d. Lubricate the periphery of the
oil pump drive shaft (2) with
engine oil. Then, slide the
shaft through the bushings (5
and 6) in the pump body (24)
and cover (19) and check for
freeness.
e. Remove two screws and oil
pump cover (19) from the
pump body (24).
f. Install a new oil seal (37)
in the oil pump cover (19) as
follows:
(1) Place the oil pump cover
(19) on the bed of an
arbor press with the
outer end of the cover
facing up.
(2) Apply a thin coat of
sealing compound to the
outside diameter of the
oil seal (37) casing.
6-724
|
||
|
||
