| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-36. TRANSMISSION OIL PUMP (Continued).
LOCATION/ITEM
ACTION
REMARKS
ASSEMBLY (Cont)
g. Install the oil pump inner
rotor (1) on the oil pump
drive shaft (2) as follows:
(1) Install one of the inner
rotor snaprings (29) in
the second snapring
groove from the non-
splined end of the oil
pump drive shaft.
(2) Apply a small amount of
cup grease on the inner
rotor drive pin (28);
then, place the drive
pin in the small pocket
in the side of the shaft
between the two snapring
grooves.
(3) Place the inner rotor (1)
over the end of the shaft
with the slot in the inner
diameter of the rotor in
alignment with the drive
pin (28). Slide the rotor
on the shaft and over the
drive pin and against the
snapring.
(4) Install the second snap-
ring (27) in the snapring
groove next to the rotor.
h. Lubricate the periphery of
the outer rotor (3) with
engine oil. Then, place the
outer rotor in the rotor
cavity i n the oil pump body
(24).
6-726
|
||
|
||
