TM 55-1905-221-14-4
6-38. TRANSFER GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
h. Install the drive flange (17) on
the power driven shaft (3) as
follows:
1.
Lubricate the splines of the
driven shaft, and the oil seal
contact surface on the outside
diameter of the drive flange
with engine oil.
2.
Start the drive flange straight
on the end of the driven shaft
and, with the splines in
alignment, push the flange
tight against the inner race
of bearing.
3.
If necessary, use a heavy
plastic hammer and tap the
drive flange onto shaft.
4.
Lubricate the threads on
driven shaft with engine oil,
then thread the retaining
nut (18) tight against drive
flange. Do not tighten at
this time.
i. Support the transfer gear housing
on wood blocks with the forward
face of gear housing up, and high
enough for the driven shaft to
clear the floor.
j. Place the power driven gear
spacer (39) straight over forward
end of driven shaft (3) and slide
it against the shoulder on shaft.
k. Lubricate the splines inside the
power driven gear (2) with engine
oil.
6-814