| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-38. TRANSFER GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
CAUTION
Do not attempt to tighten the driven gear or drive flange retaining nuts by using a hammer with
drift or chisel. Damage to the nuts will occur. Also, the proper torque cannot be obtained when
tightening the nuts in this manner.
t. Install the power driven
shaft pilot bearing (13) on
driven shaft as follows:
1.
Heat the ball bearing in
hot oil to approximately
180 (82 ).
F
C
2.
Start the bearing straight
If necessary,
over the end of the shaft
tap the bearing
with the number on the
into place on
race of the bearing facing
the shaft with a
out away from the driven
plastic hammer.
gear, and slide it down
against the shoulder on
the shaft.
6-821
|
||
|
||
