| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-38. TRANSFER GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION
16. Transfer
a. Thread an eyebolt into tapped
Gear Housing
hole at each side of the
transfer gear housing, then
attach a chain hoist and
sling to the eyebolts.
b. Affix a new gasket (33) to
the rear face of adaptor
plate (10).
c. Lubricate the splines of
both drive shafts (4), the
driven shaft pilot bearing
(13) and the two drive gear
bearings (5) with engine
oil.
d. With the blocking still in
place beneath the two engine
flywheel housings, same as
when the transfer gear
assembly was removed,
position the gear assembly
directly in back of the
adaptor plate with the drive
shafts in line with the
center of drive gears.
6-822
|
||
|
||
