| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-39. REVERSE GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
DISASSEMBLY (Cont)
h. Bring the ram of the press
down on the brass bar and
force the oil transfer sleeve
out of the gear housing.
Catch the oil transfer sleeve
and brass bar by hand to
prevent them from falling on
the floor.
NOTE
If the reverse clutch drive pins (14) in the inner face of the reverse gear housing
(19) are damaged or worn excessively, they should be removed as outlined in
steps i through k below.
i. Place a scribe mark along one
side of each clutch drive pin
on the gear housing to use as
a guide when replacing the
drive pins.
j. Attach a suitable slide hammer
and a 5/16 inch-18 adapter to
the drive pin. Remove the
drive pin with a few sharp
blows against the shaft
handle with the weight.
k. Remove the two remaining
drive pins in the same
manner.
6-852
|
||
|
||
