| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-39. REVERSE GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
NOTE
Since one flywheel-to-crankshaft bolt hole is offset, the flywheel can be installed in one position
only.
z. Rotate the flywheel until
the dowel pin holes in the
flywheel align with the
dowels in the crankshaft.
Then, pilot the flywheel over
the dowels. Install two of
the flywheel-to-crankshaft
bolts (47) and tighten them
sufficiently to draw the
flywheel against the end of
the crankshaft.
aa. Remove the flywheel lifting
tool and the two bolts that
were used to draw the
flywheel up against the
crankshaft.
ab. Place the pilot bearing
retainer (49) up against the
flywheel with the bolt holes
in alignment. Then, install
the six flywheel-to-crankshaft
bolts (47). Tighten the
bolts to 150-160 ft-lb
(203.48-216.93 Nm) torque.
ac. If the flywheel attaching
bolts (47) have drilled
heads, lock each pair of
bolts together with lockwire
(48).
ad. Place the forward clutch
plate (3) in the flywheel
(1) next to the piston (5)
with the spring loaded side
of the plate inside the
flywheel.
6-879
|
||
|
||
