| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-39. REVERSE GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
25. Reverse Gear
a. Support the reverse gear
Housing to
housings (19) (forward face
Reverse Gear
down) on three wood blocks
Adapter
approximately 6 inch high,
Plate
with the top of each
housing facing the same
direction.
NOTE
The three wood blocks should all be the same thickness, so the housing will be level.
b. Remove all traces of the old
gasket (64).
c. Place a new gasket (64) over
the attaching bolts (65) in
the rear face of each reverse
gear housing (19).
d. Position the reverse gear
adaptor plate (22) over the
top of the reverse gear
housings (19) with the flat
smooth side of the adaptor
plate facing the reverse gear
housings, and the top of the
plate facing the top of the
housings.
e. Lower the adaptor plate (22)
straight over the attaching
bolts (65) in both reverse
gear housing (19) and against
the gaskets (64).
f. Install the elastic stop nuts
(38) and draw the adaptor
plate down tight against the
housings. Tighten the nuts
to 83-93 ft-lb (112.5-126.1
Nm) torque.
6-887
|
||
|
||
