| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-41. POWER TAKE OFF COUPLING AND VIBRATION DAMPER (Continued).
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION (Cont)
3. Place a 1/4 inch steel
plate approximately 4 inch
square on the bed of an
arbor press, then support
the adapter (31) with oil
seal, rear face of adapter
down, on top of the steel
plate. Be sure the center
of the adapter is resting
flat on the steel plate.
4. Place tool J3154-04 with
suitable plates on top of
the oil seal (32) and under
the ram of the press as
shown below. Then, press
the oil seal (32) straight
into the adapter until the
oil seal contacts the steel
plate on the bed of the
press.
6-934
|
||
|
||
