| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-41. POWER TAKE OFF COUPLING AND VIBRATION DAMPER (Continued).
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION (Cont)
b. Install a 1/2"-13 X 6" pilot
stud in two of the attaching
bolt holes, diametrically
opposite each other to support
the adapter.
c. Place a new adapter gasket
(34) over the pilot studs and
against the end plate. Then
trim the ends of the gasket
off flush with the bottom
edge of the cylinder block.
d. Place the power take-off
adapter (31) and oil seal
assembly over the crankshaft,
and guide the pilot studs into
the bolt holes of the adapter,
being careful not to damage
the oil seal. Slide the
adaptor straight back over the
pilot studs and dowel pins and
against the gasket (34) as
shown below.
6-935
|
||
|
||
