INSTALLATION - TM-55-1905-222-140219

Custom Search

REPLACE PROPULSION CONTROL HEAD

TM-55-1905-222-14 Landing Craft Mechanized (LCM-8) (ROHR and Gunderson Models) (1905-01-284-2647 AND 1905-01-284-2648) Manual

TEST

TM 55-1905-222-14

4-22

REPLACE PROPULSION CONTROL HEAD (Continued).

Remove clevis (17) and pin (18) from clutch

pivot plate (19).

Remove capscrew (20),

flat washer (21),

lockwasher (22), and locknut (23).

Remove four capscrews (24) from end plate

(25). Remove end plate (25).

Remove clevis (26) and pin (27) from throttle

cam (28).

Discard old control head.

INSTALLATION

INSTALL PROPULSION CONTROLS.

Install clevis (17) on clutch pivot plate (19) and

secure with pin (18).

Install retainer (16) and secure with Phillips

screws (15).

Install clevis (26) on throttle cam (28) and

secure with pin (27).

Install end plate (25) and secure with capscrews

(24).

Install capscrews (20), flat washers (21),

lockwashers (22) and locknuts (23).

Install gasket (14), making sure to align the

gasket holes with the mounting holes in the

plate cutout.

Install propulsion

control

head assembly.

Secure the frame (13) with four screws (9),

nuts (10), lockwashers (11) and washers (12).

Install the dome (8).

Secure dome (8) with two screws (7).

4-44