| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
5-9 REPLACE CLUTCH LINKAGE (Continued).
INSTALLATION
1.
ASSEMBLE AND INSTALL
TRANSMISSION
CONTROL ROD ASSEMBLY.
a.
Install coupling tube (24) on rod ends (21). Adjust
to length " " recorded above.
B
b.
Install rod ends (21) and secure with lockwashers
(23) and hex nuts (22).
2.
CONNECT CLUTCH CABLE TO CONTROL HEAD
IN PILOTHOUSE.
a.
Drop transmission end of clutch cable into engine
room through access in pilothouse.
b.
Install cable connector (4) and jam nut (6) to clutch
cable (7).
c.
Install cable clamp (9) and secure with screws (8).
d.
Install cable connector (4) into retainer plate (5)
and secure with pin (3).
e.
Install retainer (2) and secure with these screws
(1).
3.
CONNECT CLUTCH CABLE AND ARTICULATOR
TO BLACK KNOB CONTROL UNIT IN ENGINE
ROOM.
a.
Ensure that clutch cable is routed to engine room
as required.
b.
Install clutch cable (20) onto cable adapter bushing
(19) and secure with lock nut (18).
c.
Pass cable adapter bushing (19) through hole in
control unit (16). Hand tighten screw (15). (Make
sure only the bottom end of the bushing is clamped
In the control unit).
5-24
|
||
|
||
