REMOVAL - TM-55-1905-222-140271

Custom Search

REPLACE CLUTCH LINKAGE

TM-55-1905-222-14 Landing Craft Mechanized (LCM-8) (ROHR and Gunderson Models) (1905-01-284-2647 AND 1905-01-284-2648) Manual

INSTALLATION

TM 55-1905-222-14

5-9 REPLACE CLUTCH LINKAGE (Continued).

DISCONNECT

CLUTCH

CABLE

AND

ARTICULATOR FROM THE BLACK

KNOB

CONTROL UNIT IN ENGINE ROOM.

Remove nut (10) and washer (11), remove cable

connector (12).

Loosen locknut (13) and remove cable connector

(12) from articulator (14).

Remove screw (15) from control unit (16).

Loosen locknuts (17 and 18) and remove cable

adapter bushing (19) from articulator (14) and

clutch cable (20).

Observe cable route from pilothouse to engine

room. Pull clutch cable (20) down.

DISCONNECT TRANSMISSION CONTROL ROD

ASSEMBLY FROM CONTROL UNIT.

Measure and record the length "B" from center to

center of the rod ends (21) before removing.

Remove hex nuts (22) and lock-washers (23),

remove rod ends (21) from coupling tube (24).

NOTE

Hex nuts (25) may be loosened to disconnect rod end (21) from connecting

rod (22). Do not disconnect unless adjustment is necessary.

LUBRICATION

LUBRICATE BLACK KNOB CONTROL UNIT

Apply two or three shots of grease from a grease

gun to the grease fitting on the lever of the black

knob control unit.

5-23