| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
5-22
REPLACE RAMP WINCH HYDRAULIC MOTOR (Continued).
d.
Remove one pipe plug (6) from the top of the primary housing (2) to allow air to enter.
WARNING
Care must be taken to insure that spring cover is removed evenly as
it carries the full spring load for the winch brake.
Failure to
remove cover evenly could result in personnel injury.
e.
Remove remaining capscrews (4) and seal washers (5) by slackening each capscrew (4) half a turn at a time.
f.
Withdraw the spring cover (1) when all the spring load has been removed.
NOTE
In most cases there will be a spring in every hole, but in certain
applications fewer springs are required and it is important that they
be located symmetrically when they are replaced. Note and mark
any hole that does not contain a spring.
g.
Remove springs (7) from spring cover (1).
h.
Remove and discard preformed packing (8)
from spring cover (1).
i.
Remove and discard preformed packing (9)
from the motor assembly (3).
j.
Remove snap ring (10) and motor assembly
(3).
k.
Remove primary sun gear (11) if it has
remained on the motor shaft.
5-51
|
||
|
||
