| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
5-37 REPLACE RUDDER (Continued).
k. Align holes in nut (24) with hole in rudder stock
and install cotter pin (23).
I. Tighten nuts (31 and 36).
m Install crank assembly (22) onto upper rudder
stock (18) with bolts (21), washers (20), and nuts
(19).
2.
INSTALL TIE ROD AND CYLINDER
ASSEMBLY
a Place tie rod (13) in position.
b Re-connect clevis (12) to end of tie rod (13).
c. Re-connect clevis (14) on end of hydraulic
cylinder (15), Install clevis pin.
d. Re-connect universal rudder clamp (16) of rudder
angle transmitter (17) to the rudder stock (18).
3.
INSTALL RUDDER.
WARNING
At least four (4) personnel are required to install the rudder assembly in
the craft to avoid the possibility of injury. This assembly weighs
approximately 200 lbs (90.718 kg).
a. Slide rudder assembly (10) into position on
skeg bar (11).
b. Lift up on rudder assembly (10) until lower
rudder flange (9) and upper rudder flange (8)
join together Ensure that rudder assembly aligns
with bolt holes in skeg bar.
c. Secure upper and lower flange with bolts (7),
washers (6), and bolts (5).
5-95
|
||
|
||
