| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
6-5 REPAIR ALTERNATOR (Continued).
3
INSTALL RFI CAPACITOR
Install new RFI capacitor (31) in
rear housing and secure to the three
AC terminals with flat washers (30),
lockwashers (29) and locknuts (28)
4
INSTALL REAR BEARING AND REAR
BEARING RETAINER
a. Support rotor (22) in arbor press
and place the new rear bearing (27)
over the end of the shaft.
b. Dress rotor leads away from work
area and press bearing (27) on shaft
until Inner race contacts the
shoulder
c. Install bearing retainer (26)
5
INSTALL SLIP RINGS.
a. Wrap leads around slip ring
terminals, and solder with rosin core
b. Re-test electrical circuit to insure
that a short circuit or ground did
not develop during repair operation.
c. Guide both rotor winding leads
through a single square passage In
the slip ring hub Hand press the
slip rings (25) on the shaft while
maintaining alignment of winding
leads and passage.
d. Install lockwashers (24) and cap
screws (23); tighten to 45 inch
pounds
6-16
|
||
|
||
