| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
6-10
REPAIR RAMP WINCH (Continued).
e. Take the primary planet gear which has been
checked for rotation, as above, and place one
spacer (49) on each side of the primary planet
gear next to the roller bearings. (50) Hold
this assembly opposite one of the
gear
openings in the primary planet hub (45) so that
the cross hole drilled in the end of the
primary planet pin (46) is on the same side of
the gear openings as the drilled rim of the
primary planet hub (45). Now hold the
primary planet gear (48) across the spacers (49)
with one hand, and remove the primary planet
pin (46) by gripping it on the drilled end with the
other hand.
f.
Insert the gear assembly into the planet hub
so that the bore of the gear lines up with the
planet pin hole in the planet hub (45).
g. Install a primary planet hub (45).
As
the
primary planet pin (46) enters the primary planet
gear (6), rotate the gear slowly in the
direction for free rotation so that the primary
planet pin (46) will pass freely through the
cam locks (52 and 53). Tap the primary planet
pin (1) through the planet hub (45) until the
drilled hole in the end of the primary planet pin
(46) lines up with the hole in the rim of the
planet hub (45).
h. When the hole In the end of the primary planet
pin (46) is lined up with the mating hole in the
rim of the planet hub (45), install pin (44). Drive
pin <13) into the planet hub (45) until it is
approximately 1/32" away from the bore in the
planet hub that carries the bushing (43).
6-53
|
||
|
||
