| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
6-17 REPAIR RECHARGING PUMP (Continued).
d. Put a light coat of grease or petroleum jelly on the
outside diameter of the roller bearing (46) Press the
roller bearing (46) Into the bore of the mounting flange
assembly (39) until it is flush with the surface
e. Lubricate new oil seal (45) and press into the bore of
the mounting flange assembly (39) to a depth of 1/4
inch below the surface of the flange Ensure that the
garter spring in the oil seal is facing In the direction of
the roller bearing.
f.
Install washer (40) on drive shaft (9) Using a shaft seal
installation tool (Part No EHS 41-1533), Install
mounting flange assembly (39) and '0O' ring (47) over
drive shaft (9)
g. Secure mounting flange assembly (39) with two bolts
(37) and lockwashers (38) before removing shaft seal
installation tool
h. Install check ball (14), spring (13) and hex plug (10)
with a new 'O'ring (11).
I.
Install spring (25), inlet valve (24), and adapter fitting
(21) with new 'O' ring (23) and back-up ring (22).
J. Install valve seat (20) if removed. Install, check ball
(19), valve seat (18), spring (17) and adjusting screw
(16) Install unloading valve cap (15) loosely until final
pressure adjustment is obtained
k. Install back-up ring (29), '0' ring (30) and back-up ring
(31) on valve plunger (28). Install plunger assembly
into pump housing (12). Install '0' ring (27) on hex plug
(26) and screw into pump housing (12)
6-92
|
||
|
||
