| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-10
Table 2-2. Operator/Crew Preventive Maintenance Checks and Service - CONT
B - Before
D - During
A - After
W - Weekly
M - Monthly
INTERVAL
PROCEDURES
EQUIPMENT IS
ITEM
ITEM TO BE
CHECK FOR AND HAVE REPAIRED
NOT READY/
NO
B
DA W M
INSPECTED
OR ADJUST AS NECESSARY
AVAILABLE IF:
87
Ship's Service
Diesel Generator
(Port) -
continued
Start Control
Start engine and note action of
starter mechanism, particularly
whether mechanism has adequate
cranking speed and whether it
engages and disengages without
unusual noise when the control
is operated. Set throttle so
that the engine will run at
normal warmup speed until
prescribed operating tempera-
ture is reached. If the oil
pressure gauges do not indicate
the proper pressure as specified
within 30 seconds, stop the
engine.
88
Fuel
Filter/Coalescer
Differential
Check differential pressure
Differential
Pressure
gauge, reading should be less
pressure above
than 18 psi. Refer to unit
18 psi.
maintenance.
Exterior
Visually inspect exterior for
Class III
obvious damage or leaks. Refer
leakage.
to unit maintenance
89
Fuel Transfer
Visually inspect pump for
Hand Pump
leaks, loose connections, and
damage.
90
Fuel Transfer
Visually inspect pumps for
Pumps
leaks, loose connections and
damage. Check pressure gauges
on the side of the fuel
filter/coalescer for normal
readings (15 inches suction, 30
inches discharge).
2-262
|
||
|
||
