| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-10
(8)
Transfer oil from lube oil storage tank to Main Engine Sumps and SSDG Engine Sumps.
(a) Close all valves in Lube Oil Purification and Transfer Piping System (FIGURE 2-165).
(b) To use HAND PUMP NO. 1, open LO-1, STORAGE TK SUPPLY (34), and LO-3, R HAND PUMP
NO. 1 DISCH (33).
(c) To use HAND PUMP NO. 2, open LO-2, STORAGE TK SUPPLY (1), and LO-4, HAND PUMP NO.
2 DISCH (2).
(d) To transfer lube oil to STBD MAIN ENG, open LO-25, SUMP SUPPLY/PURIFIER RTNBD ENG
ST
(15).
(e) To transfer lube oil to PORT MAIN ENG. open LO-24, SUMP SUPPLY/PURIFIER RTN PORT ENG
(6).
(f) To transfer lube oil to SSDG #1, open LO-27, SUMP SUPPLY (20).
(g) To transfer lube oil to SSDG #2, open LO-26, SUMP SUPPLY (7).
(h) When engine has been selected and correct valve alignment made, operate hand pump in a
clockwise direction, fill the selected engine sump to full mark on engine dipstick.
(i)
Close all valves in Lube Oil Purification and Transfer Piping System.
(9)
Discharge oil from dirty oil tank.
(a) Close all valves in Lube Oil Purification and Transfer Piping System.
(b) Open LO-34, DIRTY OIL TANK SUCTION (11).
(c) Open LO-37, DIRTY OIL PUMP DISCH (38).
(d) Open LO-36, DIRTY OIL PUMP SUCT (39).
NOTE
Next higher level of maintenance will install IOPP flange.
(e) If dirty oil is to be discharged on the starboard side, connect discharge hose to STBD dirty oil deck
connection, open STBD DIRTY OIL DISCH.
(f) If dirty oil is to be discharged on the port side, nnect discharge hose to port dirty oil deck
co
connection, open PORT DIRTY OIL DISCH.
(g) On Auxiliary Motor Control Center (FIGURE 2-163), set DIRTY L.O. PUMP P205-12 circuit breaker
(3) to ON position.
(h) On Dirty Oil Discharge Pump TYPE-I Motor Switch (FIGURE 2-166) release LOCK (3) by sliding
downward and press START pushbutton (1).
2-469
|
||
|
||
