| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-10
(b) Release DEVILS CLAW (5, FIGURE 2-176).
(c) On Bow Anchor Windlass engage CLUTCH LEVER (1).
NOTE
If clutch does not engage, jog the drive gently by turning HAUL BACK-PAY OUT
switch (4, FIGURE 2-177) to haul back, and then quickly turning it back to neutral.
This allows the clutch to engage, taking the strain off CHAIN STOPPER.
(d) Lock CLUTCH LEVER (1, FIGURE 2-176) in engaged position.
(e) Slowly turn HAND BRAKE WHEEL (2) counterclockwise to release brake.
(f) On Bow Anchor Windlass Control Panel (FIGURE 2-177), turn HAUL BACK-PAY OUT switch (4)
counterclockwise to the HAUL BACK position to haul in the anchor chain.
(g) On Bow Anchor Windlass (FIGURE 2-176) turn HAND BRAKE WHEEL (2) clockwiseet brake.
to s
(h) Engage DEVILS CLAW (5).
(i) Release CLUTCH LEVER (1).
NOTE
If clutch does-not release, jog the drive gently by turning HAUL BACK-PAY OUT
switch (4, FIGURE 2-177) to PAY OUT, and quickly releasing. Set DEVILS CLAW
(5, FIGURE 2-176). This allows the clutch to release.
(5) Warping Head operatio.
n
WARNING
Before operating windlass, be sure personnel and foreign objects are clear of
warping head, chain, and related components. Moving windlass parts can cause
serious personal injury or death.
High pressure hydraulic systems can cause serious personal injury in the event of
equipment failure.
DO NOT operate hydraulic motor with brake engaged.
(a) Startup Procedures.
1
On Main Switchboard (FIGURE 2-174), set FWD DECK MCHRY MCC circuit breaker (1) to ON
position.
2
At Forward Deck Machinery Motor Control Center in Tunnel (FIGURE 2-175), set BOW WINDLASS
No. 1 circuit breaker (1) and BOW WINDLASS NO 2 circuit breaker (4) to ON position.
2-503
|
||
|
||
