| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-10
(11) Rotate CHOKE control (5) to full counterclockwise, OFF position.
f. Manual Startup With Manual Primin.g
(1) Unscrew and remove INLET PLUG (5, FIGURE 2-200) from priming inlet.
(2) Fill pump with water until filler inlet is full, replace plug (5) in filler inlet.
(3) Connect red battery cable to (+) positive pole next to carburetor and black cable to (-) negative pole
next to main pump suction inlet.
(4) Place OFF-START-RUN switch (2, FIGURE 2-201) in start position.
(5) Advanced SPEED control (6) clockwise direction, to one quarter of full throttle.
NOTE
If engine is cold, advance CHOKE control (5) fully clockwise (closed), then half
open as engine starts, and fully open for running.
(6) Pull manual start pull cord (1, FIGURE 2-202) in a quick steady motion until engine starts.
CAUTION
Do not allow pump to run more than 2 minutes without water flowing. Lack of
cooling water could cause severe impeller and exhaust system damage.
(7) Slowly turn water discharge valve (3, FIGURE 2-200) clockwise until indicating pressure on gauge
(1, FIGURE 2-201) and advance speed control (6) as required.
(8) Rotate CHOKE control (5) to full counterclockwise, OFF positi6n.
.
a. Dishwasher (FIGURE 2-20).
3
CAUTION
Do not attempt to operate without wash tank being properly filled. Dry rotation will
damage motor seals.
(1) Open door.
(2) Press main ON-OFF switch (2) to ON position.
(3) Close door.
(4) Press and hold START-FILL switch (1) in FILL position for 50 seconds or until water can be heard
flowing down drain.
2-551
|
||
|
||
